How do I clear out all settings and start again

If you want to clear out all settings in the Humax and start again you can perform a factory reset, to do this just following these steps:

Note: Your existing recordings will be safe as long as you do NOT tick the Format HDD check-box in step 4 below.

 

  1. Press the MENU button on the remote control, then scroll down and select Settings and press ok.

    01_Factory_Reset.jpg
  2. Scroll down and select Installation and press ok. After selecting Installation it will ask for a Password. When asked for the Password enter your Humax's PIN number (the default PIN number is 0000). 

    02_Factory_Reset.jpg

    03_Factory_Reset.jpg
  3. Select Factory Default and press ok.

    04_Factory_Reset.jpg
  4. Leave 'Format HDD' unticked (you do NOT want to format the hard drive). Then select Yes and press ok. When asked for the Password enter your Humax's PIN number (the default PIN number is 0000). 

    05_Factory_Reset.jpg

    06_Factory_Reset.jpg

    07_Factory_Reset.jpg
Once completed the Humax will reboot and start with the first time setup wizard. A guide on the steps to run through the setup wizard can be found at Setting up IceTV on the Humax HDR-7500T.
 
Have more questions? Submit a request

0 Comments

Article is closed for comments.