Programs in the Guide are out by 1 Hour

Note: If your state has recently changed from Daylight Saving to normal time (or vice versa), please instead follow these directions.

On the Beyonwiz, each different time mode (Auto, Manual and Network) has 2 important settings that must both be set correctly. If either the Time Offset or the Daylight Savings option are incorrectly set then the start times of programs in the guide can be wrong even though the clock is showing the correct time. An incorrectly set Daylight Savings option will cause the start times of program's in the guide to be off by 1 hour. If the Time Offset is incorrectly set the program's start times in the guide can be off by any amount in 30 minute increments up to 24 hours.

Below are the Beyonwiz settings to use for each Time Mode, and for each State.

NSW, ACT, VIC or TAS

Go to 'Setup > Config. > Time' and then:

If you are using AUTO Mode, set the following:

• Daylight Saving = Disable  (Enable it when Daylight Savings starts)
• Region = NSW/ACT or VIC or TAS
• Exit to live TV and it will get the correct time within a minute.

If you are using MANUAL Mode, set the following:

• Time Offset = +10:00  (set it to +11:00 when Daylight Savings starts)
• Current Time = "set to correct date and time"
• Exit to live TV and it will get the correct time within a minute.

If you are using NETWORK Mode, set the following:

• NTP Server IP or Name = "set to valid NTP server IP or name"
• Time Offset = +10:00  (set it to +11:00 when Daylight Savings starts)
• Exit to live TV and it will get the correct time within a minute.

SA or NT